Mkorish
Member
Has anyone used resin from the epoxy resin store? I'm looking for something that I can use on pens, coasters, cutting boards.
They have allot of good reviews.
They have allot of good reviews.
Resin ?
- Thread starter Mkorish
- Start date
Signed-In Members Don't See This Ad
Signed-In Members Don't See This Ad
Woodchipper
Member
Following.
jttheclockman
Member
Looks Like I found my new place for LD resin also. Save $5 on price and another $3 on shipping as compared to Turners Warehouse. Glad I checked. Thanks.
RGABEL
Member
I have gotten several of the resins from there and all have worked great for my needs. Seems to be very reasonable in cost as well. They also have several sales throughout the year.
Mkorish
Member
I know it's been awhile, I finally used some resin I got from the epoxy resin store. I went with the clear cast 7000 and I finally opened it yesterday to use it. When I was going to mix it I noticed that part B was thick like glue and I had it stored in the house.
Anyone have any info on this or used it?
Anyone have any info on this or used it?
Monty
Group Buy Coordinator
Try microwaving it for 15 to 30 seconds at a time until it thins down. I've had success using this method before.
darrin1200
Member
This happens with my Alumilite as well. Apparently it is normal for B to thicken up over time.
I set the jug in a pail of boiling hot water, while I prep my casting table, after a few minutes it's fine.
woodwzrd
Member
The B side of almost all resins is always thicker. I primarily use JB Royal and it is the same. I have cast several other epoxies and urethanes and B is always thicker. I either set it in front of my heater to warm it up or like Darrin, will soak it is a pail of hot water.