Watch Parts Video

[EBorraga]

I did a small video on watch parts last night. Hope you enjoy!


https://www.youtube.com/watch?v=4Ncfb9QbBPk

 

[Dalecamino]

Awesome video! Thanks for posting this. Straight...to the point...informative, and nothing phony. Not acting like you're doing a commercial. So what if it cut short? I got all I needed. :wink: Thanks Ernie!

 

[EBorraga]

Awesome video! Thanks for posting this. Straight...to the point...informative, and nothing phony. Not acting like you're doing a commercial. So what if it cut short? I got all I needed. :wink: Thanks Ernie!

For some reason my phone stop recording at the end. But you got 99% of it!

 

[ALA]

Job well done! Thanks for sharing.

 

[EBorraga]

Job well done! Thanks for sharing.

Thank you, and hope it helps people understand how they're made!

 

[m4skinner]

For some reason my phone stop recording at the end. But you got 99% of it!

I was wondering what happen, I was half way through my popcorn and the next thing I new it was over. lol

It was a good video.

 

[keithlong]

Enjoyed the video. This is something that I want to do down the road.

 

[EBorraga]

Enjoyed the video. This is something that I want to do down the road.

Hopefully this helps ya!!

 

[mark james]

Very nice - I need to get your autograph now!

 

[Pen Zen]

This is the kind of thing I come to this forum for. I really appreciate the people that take the time and go to all of the trouble to share there knowledge. Thank you.

 

[Cwalker935]

Very nice job on the video. I've had some faces and gears for a while with the intention of making a watch parts pen, you may have just pushed me over the top due to do it.

 

[EBorraga]

This is the kind of thing I come to this forum for. I really appreciate the people that take the time and go to all of the trouble to share there knowledge. Thank you.

I don't mind sharing my process. Alot of people are hush hush on how they do it. I hope you put it to good use!!

 

[dogcatcher]

If you need to thin the part, a good method is to build a jig similar to jeweler's "hand faceting jig". This will get you 90 degrees to the "grinder" and a flat surface.