Dave Winters
Member
Anybody know of a source for a replacement gasket? I have a used pot that won't hold air... inside dia 8 1/2", outside dia. 9"
Thanks!
Thanks!
Source for pressure pot gasket
- Thread starter Dave Winters
- Start date
Signed-In Members Don't See This Ad
SuperDave
Member
Dave,
I got a 12" square of "Red Rubber" from Home Depot for less than $5 and cut out a gasket. It was in the plumbing department. It might work for you too.
Dave
I got a 12" square of "Red Rubber" from Home Depot for less than $5 and cut out a gasket. It was in the plumbing department. It might work for you too.
Dave
S
spiritwoodturner
Guest
Hey Dave,
Howdy from Parker! Bet you weren't 55 degrees today. But then, I bet we didn't have 2 feet of fresh powder either...
Do you know what make of pot it is? Hopefully, it's a HF, because you could easily get a replacement gasket from them. My guess is there is no ID, or you would have already known that. Binks gaskets are all over the internet too. Are there any industrial paint stores up there near you? Or even a Kwal Howell.
Anyway, let me know if there's anything I can do down here for you!
Stay warm,
Dale
Howdy from Parker! Bet you weren't 55 degrees today. But then, I bet we didn't have 2 feet of fresh powder either...
Do you know what make of pot it is? Hopefully, it's a HF, because you could easily get a replacement gasket from them. My guess is there is no ID, or you would have already known that. Binks gaskets are all over the internet too. Are there any industrial paint stores up there near you? Or even a Kwal Howell.
Anyway, let me know if there's anything I can do down here for you!
Stay warm,
Dale
Leather Man
Member
Dave,
I have an old Binks pot. I got a new gasket for it at an auto paint store.
Ben
I have an old Binks pot. I got a new gasket for it at an auto paint store.
Ben