sgimbel
Member
I may have mixed 1/8 to 1/4 oz of water with about a 1 1/2 quarts of Silmar 41. What's that going to do to me?
Silmar/water
- Thread starter sgimbel
- Start date
Signed-In Members Don't See This Ad
Signed-In Members Don't See This Ad
EarlD
Member
Not much if you don't drink it.
Brooks803
Member
I don't really know, but maybe pour 1oz of resin in a mixing up and catalyze to see if it sets up. If it does you should be good to go.
Sylvanite
Member
Most likely it will either inhibit curing, or cause the resin to turn a milky color. Try a sample with a bit of extra MEKP and hope for the best.
Good luck,
Eric
Good luck,
Eric
ZanderPommo
Member
when I'm casting and resin drips into the mold, it rises to the top and doen't mix with the pr. I dont imagine that it will go well but theres only one way to tell
sgimbel
Member
Thanks for the advice.
Usually the water will rise to the surface. In some of the molds I used back when I first started, I managed to poke holes in the bottom and water seeped in. It surfaced like bubbles do and they were fine.
Of coarse, I have never added that amount of water, but used to use water based colors without any affect. Do as suggested and try a small amount.
Of coarse, I have never added that amount of water, but used to use water based colors without any affect. Do as suggested and try a small amount.
toddlajoie
Member
Hmm, I've seen people on this site cast a lot of interesting stuff, but never thought of trying to cast WATER!! You guys are SOOO creative!!!:biggrin: