Segmenting with M3 Blanks

[LL Woodworks]

Has anyone done any segmenting with M3 blanks? More specifically, any segmenting with M3 / Aluminum / Wood? Is 2-part epoxy or CA better for segmenting M3? I usually use Locktite 2-part epoxy for wood and aluminum projects.

Thanks for any feed back as the M3 blanks are to expensive to experiment with.

 

[Jim Burr]

Haven't seen that one yet Lynn. I only use CA to fill segmented blanks as I turn them. Assembly is done with 2-part epoxy.

 

[firewhatfire]

I use ca when doing segments. Never had a m3 blank to try

 

[jttheclockman]

I think you can't go wrong using an epoxy. I have never used that material so I can not say for sure but do know I would have tried epoxy for sure only because that is what I use most of the times.

 

[hewunch]

This was done with Thick CA

 

[USNR'03]

This was done with Thick CA

OH MY GOD!!!!!!!!!!!!!!!!!!!! That is Killer.

 

[jyreene]

I have one I did with Koa and M3. I used Epoxy and it worked just fine.

 

[jyreene]

Here it is.

 

[LL Woodworks]

I have one I did with Koa and M3. I used Epoxy and it worked just fine.

Thanks Ty - that make me feel more comfortable. Thanks everyone for you input.
Regards to all.