MRDucks2
Member
Always had my lathe against a wall expect one time when I angled it. After a couple of threads on AAW I realized I was losing a lot of space on the wall behind the lathe.
Was passing through Missouri and stopped by Grizzly to buy a heavier mobile base, had my son weld some extensions on it and put it under the old P90.
Swung it 90 degrees to the wall, off enough to work on it and run dust collection, remounted my grinder to a smaller stand and feel pretty good about the setup.
Table saw will shift South a foot and now have room on the wall as well as space behind the lathe for a sanding/small projects station.
Still need to recess another electrical line and put up some stud plates, but happy with progress.
Was passing through Missouri and stopped by Grizzly to buy a heavier mobile base, had my son weld some extensions on it and put it under the old P90.
Swung it 90 degrees to the wall, off enough to work on it and run dust collection, remounted my grinder to a smaller stand and feel pretty good about the setup.
Table saw will shift South a foot and now have room on the wall as well as space behind the lathe for a sanding/small projects station.
Still need to recess another electrical line and put up some stud plates, but happy with progress.
Last edited: