Suskmorrison
Member
I want to turn an acrylic pen blank then apply a label around the blank with mode podge? Has anyone done this before?
Apply a label on acrylic pen blank
- Thread starter Suskmorrison
- Start date
Signed-In Members Don't See This Ad
Monty
Group Buy Coordinator
I would use a water slide decal and seal it with CA.
There are several tutorials in the library on applying decals.
There are several tutorials in the library on applying decals.
its_virgil
Member
Agree with Monty on using a water slide decal. Not a fan of mode podge.
JohnU
Member
Also, depending on the image, if you can cut around it cleanly, you can busy build a CA finish over it but it will depend on the size of the image and the pen being made, to see id you can get the label to lay flat without any wrinkles.
Like suggested above, waterslide just work better over blanks. You can brush on a layer of microsol to soften them up so they lay flat against the blank. Then let dry and build a CA finish over it.
Like suggested above, waterslide just work better over blanks. You can brush on a layer of microsol to soften them up so they lay flat against the blank. Then let dry and build a CA finish over it.