“Short” Blank Size

Signed-In Members Don't See This Ad
MRDucks2

MRDucks2

Member
Joined
Jul 17, 2017
Messages
3,285
Location
Bristow, IN
As I am working with a bunch of wood from a retired turner, I have some pieces I can separate usable "short" blanks from pieces for casting or inlay.

My question is, what is the preferred size range for a "short" blank. My standard is 5-1/4" with a range of 5"-6" for regular blanks.

I have seen mentioned that a blank need to be 2-1/2" for a Sierra. Is that a good bottom for squaring and turning or would 2-5/8 be better?

Thanks for the feedback.


Sent from my iPhone using Penturners.org mobile app
 
Signed-In Members Don't See This Ad
If you are talking Sierra Twist, then 2 1/2" is perfectly adequate as finished barrel length is 2.21".

Even for a Sierra Click, which has finished barrel length of 2.42", a starting length of 2 1/2" is OK if you are careful.
 
If you are talking Sierra Twist, then 2 1/2" is perfectly adequate as finished barrel length is 2.21".

Even for a Sierra Click, which has finished barrel length of 2.42", a starting length of 2 1/2" is OK if you are careful and reasonably skilled.
 
For most single barrels, 2.5" to 2.625" gets it there. But, there's a large number of kits that push the 3" mark--Vertex Click, Atlas (Patriot, Polaris), many of the PSI "themed" kits (Celtic, etc)--all at 2.88" to 2.90".

earl
 
Yep, segmented blanks. I just cut a piece of a "board" from the $5 bin at Woodcraft. I got at least 12 blanks, 3/4x3/4x5, out of it and still have some left over. I pulled the copies of my pen instructions and that went up to 24 blanks for many kits. The five inch blanks are for Slimline kits, the other kits take blanks of not more that about 3 inches.
 
Woodchipper said:
Yep, segmented blanks. I just cut a piece of a "board" from the $5 bin at Woodcraft. I got at least 12 blanks, 3/4x3/4x5, out of it and still have some left over. I pulled the copies of my pen instructions and that went up to 24 blanks for many kits. The five inch blanks are for Slimline kits, the other kits take blanks of not more that about 3 inches.
Click to expand...

Yeah, when i cut a board, i sometimes cut length i need for what i'm working on, leave the rest intact so there is a degree of flexibility. Band saw is always plugged in!!
earl
 
You must log in or register to reply here.
Back
Top Bottom