Kenobi
Member
Another bowl finished , and this is probably the best I can possibly do on my small lathe. Sapeli&Maple, diam. 9.5"(24,5cm) height 4" (10cm). My hands hurts from hours of sanding,but it was worth it
Another bowl - pushin' the limits
- Thread starter Kenobi
- Start date
Signed-In Members Don't See This Ad
Signed-In Members Don't See This Ad
Hippie3180
Member
Beautiful segmenting! Very nice!Another bowl finished , and this is probably the best I can possibly do on my small lathe. Sapeli&Maple, diam. 9.5"(24,5cm) height 4" (10cm). My hands hurts from hours of sanding,but it was worth it
Jim15
Member
Great work.
PreacherJon
Member
Nice bowl... but why did it take hours to sand it... Can't figure out why your hands should be hurting?Another bowl finished , and this is probably the best I can possibly do on my small lathe. Sapeli&Maple, diam. 9.5"(24,5cm) height 4" (10cm). My hands hurts from hours of sanding,but it was worth it
Aussie
Member
What finish old mate?
Kenobi
Member
I only got basic toolrest, so on the inside, especially the bottom, the gouge was far over it,and it was difficult to keep it steady. Also,I wanted it to be shiny,so I went all the way to down to 800 grit.
Kenobi
Member
Mineral oil and beeswax
Woodchipper
Member
Nice segmented bowl!
PreacherJon
Member
Bottom feeder Bowl gouge will help with that. Also.. are you sand by hand?
Kenobi
Member
I both powertools and by hand. But fine grits always by hand.