Tranny removal - no hammering

MPVic · Dec 4, 2023

I saw Ed from Exotic Blanks show how to remove a tranny - it seemed to take a lot of hammering, and with my luck I would definitely injure myself.
So I came up with this - sorry if someone has already posted a similar method.

Darios · Dec 4, 2023

Clever.

wood-of-1kind · Dec 4, 2023

Ingenious and am so glad that you have shared this technique. I've been a member here a long time and have
never seen this method before. Thank you for posting and sharing your idea.

MPVic · Dec 4, 2023

wood-of-1kind said:
Ingenious and am so glad that you have shared this technique. I've been a member here a long time and have
never seen this method before. Thank you for posting and sharing your idea.

Thank you. The wooden MT2 was meant for a pen-press-on-the-lathe but then I thought that could be the stationary hammer against the transfer punch.

Monty · Dec 4, 2023

I do something similar, but I put the transfer punch in my drill press and press down through the tube to push the transmission out.

Wmcullen · Dec 5, 2023

That's a very useful trick. Thanks for the demonstration!!

wouldentu2? · Dec 5, 2023

Good idea, you can use a drill bit sizing card in place of the the wood to get a closer fit.

Woodchipper · Dec 5, 2023

Interesting. My father said there was a saying in the USAF, "Don't force it. Use a bigger hammer."

Tranny removal - no hammering

MPVic

Member

Darios

Member

wood-of-1kind

Member

MPVic

Member

Monty

Group Buy Coordinator

Wmcullen

Member

wouldentu2?

Member

Woodchipper

Member