It's been awhile..
- Thread starter Mkorish
- Start date
Signed-In Members Don't See This Ad
Signed-In Members Don't See This Ad
Todd in PA
Member
Nice blank and kit. 
I see a tiny bit of chip out on the clip end of the barrel. If you rub some figure eight patterns on a piece of 320 grit sandpaper, you might be able to sand those out. Your basically shortening the barrel slightly, but trying to keep the end square with figure eights.
I see a tiny bit of chip out on the clip end of the barrel. If you rub some figure eight patterns on a piece of 320 grit sandpaper, you might be able to sand those out. Your basically shortening the barrel slightly, but trying to keep the end square with figure eights.
qquake
Member
I like it! What is the wood?
Mkorish
Member
I seen that too but there was a couple other spots in the middle to do I decide to leave it and let it have "used look."Nice blank and kit.
I see a tiny bit of chip out on the clip end of the barrel. If you rub some figure eight patterns on a piece of 320 grit sandpaper, you might be able to sand those out. Your basically shortening the barrel slightly, but trying to keep the end square with figure eights.
Not sure what kind of wood it is, got in the bargain bin at wood craft.
Mkorish
Member
After looking at it, I took your advice and sanded down the best I could. One small spot yet that I was able to put begging the clip..... ThanksNice blank and kit.
I see a tiny bit of chip out on the clip end of the barrel. If you rub some figure eight patterns on a piece of 320 grit sandpaper, you might be able to sand those out. Your basically shortening the barrel slightly, but trying to keep the end square with figure eights.